L-1A 1" Aluminum Dome Tweeters
- 1" Aluminum Dome Tweeter Diaphragm
- Neodymium Magnet
- Ferrofluid® Cooling
- Computer Aided In-line 12 dB Crossover
- Flush/Angle/Surface Mounts Included
- 4-ohm System Impedance
Home > Products > Component systems >
L-1A 1" Aluminum Dome Tweeters
Read more
L-1A 1" Aluminum Dome Tweeter
Listening to balanced and bright highs makes the music come alive. The L-1A Aluminum Dome Tweeters deliver crystal clear sound reproduction without loosing any detail to your music.
These tweeters come with 3 different ways to mount them to make your tweeter install fast and easy. With an inline 12dB crossover, you do not need to worry if you are getting the proper signal input to your tweeters.
Sit back and listen with the confidence that only PowerBass tweeters can bring you.
Specifications
- Nominal Impedance: 4-ohm
- Material: Aluminum
- Sensitivity (1W / 1M): 92 dB
- Mounting Depth: 0.75 in
- VC Impedance:
- Size: 1 in
- Frequency Response: 3.5 kHz - 21 kHz
- Voice Coil Size:
- Power Handling (RMS/Peak): 50 / 100 watts
Downloads
L-1A 1" Aluminum Dome Tweeters
Recommended Products
IN STOCK NOW!
- Extruded Aluminum Casing
- Built-in Rechargeable Li-ion Battery 1900mAH
- Micro USB 5V Charging
- Enhanced Ported Bass Response
- 3.5mm Aux input
- Single 10" 175 Watt RMS Amplified Downfiring Enclosure
- Computer Optimized 10" Thin Subwoofer Enclosure
- Custom Injected Molded Cone
- Large Roll Rubber Surround
- 2" Vented KSV Voice Coil Former
- Perimeter Aero Voice Coil Venting
- Poly-carbonate/Glass Fiber Composite Turbine Basket
- Chrome Push Terminals
- 2-Tone Vinyl/Carpet Finish
- 1-Channel 275 Watt High Efficiency Class A/B Design
- High Level (Speaker)/Low Level RCA input
- Soft Delay Turn On/Off Circuit
- Auto Turn-on (high level input only)
- Variable Low Pass Electronic Crossover 50Hz - 200Hz
- Variable 12db Bass Boost EQ @ 45Hz
- Variable Gain Control
- Protection Circuit: Impedance Over-load, Speaker Short Circuit, Thermal Overheating, and DC Output
- Wired Remote Gain Control Included
- Down Firing Air Suspension Enclosure
- Heavy-Duty Reinforced Box Design
- Mounting Hardware Included
- 4-Band Dual Zone Active Equalizer Bass, Mid-Bass, Mid, High
- 3 Zone Volume Control and Output
- Variable Master Volume Control
- Front Panel Selectable Inputs - Bluetooth, Aux, RCA
- Front Panel Tri Illumination Selector - Red, Blue, Green
- Front Panel Track Selector - Track Up / Down
- 6V RMS output
- Bi-Polar PWM Power Supply
- Frequency Response: 20Hz-40KHz
- Selectable 120/80Hz Subwoofer Crossover
- Conformal Coated PCB
IN STOCK NOW!
- 12 Speaker 500 watt Amplified Bluetooth Powersports Soundbar
- IPX6 Rated
- 6 x 3.5" Square Poly Cone Woofers
- 2 x 3” Full Range Marine Grade Poly Cone Speakers
- 4 x 1” SD Mylar Tweeters
- Heavy Duty Extruded Aluminum Water Tight Housing
- LED back-lit Control Panel
- LED Visual Notifications
- Audible Power On/Off Notifications
- Built In DSP Processor w/Distortion Limiter
- Bluetooth and Wired Inputs
- 2 Volt Line Output
- Auto Turn On/Off Circuit
- Waterproof Wire Loom Connectors
- Universal L-Bracket Mounting System Included
- Universal Top or Bottom Mount Clamp Style Brackets (Sold Separately XL-SBCLAMP, XL-SBTCLAMP, XL-SBSCLAMP)
- Secondary Dash Mountable Controller Pad (Sold Separately XL-SBCON)
- CRS 4.0 Bluetooth Protocol
- >30' Bluetooth Range
- RCA Audio Output
- Power, Track Up/Down & Volume Up/Down
- USB 5V Charging Port
- 12V Remote Amplifier Turn On/Off Lead
- Detente buttons for easy use with gloves
- Water resistant cables and connectors
- Surface or Flush Mount
- Soundbar / POD Square Clamps
- Perfect for Golf Cart Applications
- For use with the XL Soundbars, or XL POD models
- Fits 0.75", 1.0", 1.25" square bars
- Non-corrosive black powder coating
- hardware included
- Soundbar / POD Thin Mount Clamps
- Perfect for Under Roof Mount Applications
- For use with the XL Soundbars, or XL POD models
- Fits 1.5", 1.75", 2" round bars
- Non-corrosive black powder coating
- hardware included
- 800 Watt High Efficiency Class D Design
- 1-OHM Stable Mono Block Amplifier
- Ultra Low Current Draw
- Double Sided Copper Plated PCB
- PWM MOSFET Power Supply
- Digital Sound Optimization Circuitry
- High Damping Control Circuit
- Variable Subsonic Filter
- High Current Voltage Ripple Rejection Circuitry
- Balanced RCA Inputs
- Auto Turn On/Off
- Remote Soft Delay Turn On/Off Circuit
- 40 Click Variable Low Pass Electronic Crossover
- 40 Click Variable Frequency/18dB Bass Boost EQ
- Variable Gain Control
- Wired Secondary Remote Gain Control Included
- Protection Circuit: Impedance Over-load, Speaker Short, Circuit, Thermal Overheating, and DC Output
- Strapable Dual Amp Power Doubling Circuit (Amp-to-Amp Bridged at 2 ohm minimum)
