PB-GAIN1 Wired Remote Level Control
- Remote Wired Variable Level Controller (secondary gain control)
- Includes Bass Knob, Cable & Mounting Screws
- For use with the following PowerBass amplifier series:
- XMA Amplifiers
- XL Amplifiers
- ASA Amplifiers
- ASA3 Amplifiers
- ACS Amplifiers
Home > Products > Amps / amplifiers >
PB-GAIN1 Wired Remote Level Control
Read more
EASY AMPLIFIER LEVEL CONTROL AT YOUR FINGERTIPS
The PB-GAIN1 gives you the control that you need to balance the bass with each song.
The PB-GAIN1 is an easy one wire install that gives you a secondary gain control in the cockpit of your vehicle to turn the bass up or down depending on your listening desires.
Specifications
PB-GAIN1 Wired Remote Level Control
Recommended Products
- New PBX logo dust cap
- 15" Dual 1-Ohm Subwoofer
- 1500 watt RMS/3000 Watts Max
- DDC Non-pressed Raw Pulp Cone
- High Roll Nitrile Butadine Rubber (NBR) Surrond
- 3.5” Vented HD BASV Voice Coil Former
- Perimeter Aero-Vent Voice Coil Cooling Vents
- Non Resonance DDC Coated Cast Aluminum Basket
- XTRA XTRA XTRA Large Triple Stacked Motor Structure
- Square Spring Loaded Nickel Plated Push Terminals
- Optimally Designed for Ported Enclosures
IN STOCK NOW!
- Extruded Aluminum Casing
- Built-in Rechargeable Li-ion Battery 1900mAH
- Micro USB 5V Charging
- Enhanced Ported Bass Response
- 3.5mm Aux input
- Single 10" 175 Watt RMS Amplified Downfiring Enclosure
- Computer Optimized 10" Thin Subwoofer Enclosure
- Custom Injected Molded Cone
- Large Roll Rubber Surround
- 2" Vented KSV Voice Coil Former
- Perimeter Aero Voice Coil Venting
- Poly-carbonate/Glass Fiber Composite Turbine Basket
- Chrome Push Terminals
- 2-Tone Vinyl/Carpet Finish
- 1-Channel 275 Watt High Efficiency Class A/B Design
- High Level (Speaker)/Low Level RCA input
- Soft Delay Turn On/Off Circuit
- Auto Turn-on (high level input only)
- Variable Low Pass Electronic Crossover 50Hz - 200Hz
- Variable 12db Bass Boost EQ @ 45Hz
- Variable Gain Control
- Protection Circuit: Impedance Over-load, Speaker Short Circuit, Thermal Overheating, and DC Output
- Wired Remote Gain Control Included
- Down Firing Air Suspension Enclosure
- Heavy-Duty Reinforced Box Design
- Mounting Hardware Included
IN STOCK NOW!
- 12 Speaker 500 watt Amplified Bluetooth Powersports Soundbar
- 6 x 3.5" Square Poly Cone Woofers
- 2 x 3” Full Range Marine Grade Poly Cone Speakers
- 4 x 1” SD Mylar Tweeters
- Heavy Duty Extruded Aluminum Water Tight Housing
- LED back-lit Control Panel
- LED Visual Notifications
- Audible Power On/Off Notifications
- Built In DSP Processor w/Distortion Limiter
- Bluetooth and Wired Inputs
- 2 Volt Line Output
- Auto Turn On/Off Circuit
- Waterproof Wire Loom Connectors
- Universal L-Bracket Mounting System Included
- Universal Top or Bottom Mount Clamp Style Brackets (Sold Separately XL-SBCLAMP, XL-SBTCLAMP, XL-SBSCLAMP)
- Secondary Dash Mountable Controller Pad (Sold Separately XL-SBCON)
- CRS 4.0 Bluetooth Protocol
- >30' Bluetooth Range
- RCA Audio Output
- Power, Track Up/Down & Volume Up/Down
- USB 5V Charging Port
- 12V Remote Amplifier Turn On/Off Lead
- Detente buttons for easy use with gloves
- Water resistant cables and connectors
- Surface or Flush Mount
- 800 Watt High Efficiency Class D Design
- 1-OHM Stable Mono Block Amplifier
- Ultra Low Current Draw
- Double Sided Copper Plated PCB
- PWM MOSFET Power Supply
- Digital Sound Optimization Circuitry
- High Damping Control Circuit
- Variable Subsonic Filter
- High Current Voltage Ripple Rejection Circuitry
- Balanced RCA Inputs
- Auto Turn On/Off
- Remote Soft Delay Turn On/Off Circuit
- 40 Click Variable Low Pass Electronic Crossover
- 40 Click Variable Frequency/18dB Bass Boost EQ
- Variable Gain Control
- Wired Secondary Remote Gain Control Included
- Protection Circuit: Impedance Over-load, Speaker Short, Circuit, Thermal Overheating, and DC Output
- Strapable Dual Amp Power Doubling Circuit (Amp-to-Amp Bridged at 2 ohm minimum)
